Winterize those sprinklers!

Winterizing the sprinkler system


Preparing your lawn sprinkler system for winter can prevent costly repairs

Preparing your lawn sprinkler system for winter can prevent costly repairs


  1. Shut off the system supply valve, usually located in a box underground.
  2. Your lawn sprinkler system should have been installed with a drain valve usually placed just downstream of the backflow preventer.
  3. Open the drain valve to allow the system to drain. If your system does not have a drain valve, open all the test cocks on the backflow preventer assembly to allow the system to depressurize and drain.
  4. Remove one or more nozzles or sprinkler heads from the farthest end of the sprinkler system to vent the system and help it to drain thoroughly. If you have an extensive sprinkler system or one with more than one zone, you may want to remove at least one nozzle or head in each zone.
  5. If your system runs up and down in an uneven lawn, you may need to purge the underground sprinkler lines with air pressure.
  6. To do this, remove all the nozzles possible and adapt an air hose to fit the ½” or ¾” pipe thread where the nozzles screw in.
  7. Attach the air hose to the system, allow pressure to build up on the air compressor to at least system operating pressure or 80 psi. Then open the air valve on the air compressor and let the air blow all the water out of the system.
  8. For a small system this usually only takes a quick blast. For larger systems or zoned systems, you may need to hook up the air compressor in multiple locations.
  9. Once you are certain that as much water as possible has been drained out of the system, replace all the nozzles.
  10. Leave the drain valves opened until spring.
  11. Deactivate the automatic timer.


If you did have to open the test cocks on the backflow preventer, close them again after the system has drained down to prevent debris from entering the backflow preventer.

Have the backflow preventer tested each spring to ensure it is operating properly.

Place a blanket of fiberglas over the valves and piping in each lawn sprinkler control box to keep them from freezing. You can also use newspapers, packing peanuts, old blankets, etc.

Thank you DIY Central for this information!

Agent Login    |    Powered by Onjax
Create Free Account or
Choose Your Agent (optional)
I agree to the Terms of Use
Keep me updated about interest rates and market information by our trusted local lending partner.
Equal Housing Opportunity Realtor MLS
or